Aqualogis Antibac-Air Filter compatible with Whirlpool Microban antibacteria air filter Note: This is NOT a Water Filter but the AIR FILTER CARTRIDGE for Whirlpool fridges 100% of the fridge air passes through this high-tech filter. Microban active ingredients are incorporated into the polymer structure of the air filter during manufacture. They are evenly distributed throughout the fibres of the entire surface area and deep within the filter itself. Whirlpool advise that air filter should be changed every six months. Anti bacterial air filter Anibac-Air fits following refrigerators: Whirlpool, Smeg, Caple, Bauknecht, KitchenAid, Kenmore, Sholtes, Ariston, Hotpoint

How to replace the filter

There are two types of air filter installations. Each one requires different steps, so identify the air filter type in your full-size refrigerator before getting started.

Type 1, follow these instructions:

Please Note: The air filter is located behind the blue LED-lighted vent cover, located on the rear wall near the middle of the refrigerator.

• Remove the air filter from its packaging.
• Pull out plastic cover over the vented cover.  We suggest removing the cover by lifting up one side of the cover, then the other. 
• Snap the filter into place.

Type 2, follow these instructions:

Install the air filter behind the vented door, located on the rear wall near the top of the refrigerator compartment.

• Remove the air filter from its packaging.
• Lift open the vented door.
• Snap the filter into place.

How to reset the air filter status (only some models)

After replacing the air filter, the air filter status will need to be reset. Directions for resetting the status will vary by model number, we recommend referencing the Use and Care Guide for specific models instructions. 

To Reset the Air Filter:

• Press and hold the AIR FILTER button for 3 seconds.
• The filter icons will turn off. When the system is reset, the air filter icon will return to its BLUE color and the words “Replace Filter” will disappear from the control panel. 

The below are the different stages you will see on the air filter display:

• GOOD - The air filter icon on the control panel lights up in BLUE.
• ORDER a replacement - The air filter icon on the control panel lights up in YELLOW.
• REPLACE air filter - The air filter icon on the control panel lights up in RED and “Replace Filter” will appear.
• EXPIRED - The air filter icon lights up in RED and “Replace Filter” flashes on the control panel.

NOTE: At any filter status, pressing and holding the AIR FILTER button for 3 seconds will reset the air filter status to Good and the air filter icon will turn off.

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi ut aliquip ex ea commodo consequat.