Aqualogis Style - Undersink Drinking Water Tap Filter Kit System Including Faucet and Accessories

You are purchasing a high quality under sink filter system which includes a high quality carbon filter, which removes chlorine, organic contaminants, odours and toxins from your water, providing high quality tasting drinking water on tap.

This Aqualogis Style filter kit comes complete with the following:

1 x Inline Carbon filter made from High grade coconut shell carbon with 1/4" PF connectors - Filter manufacturd in Europe to the TÜV, NSF Standard

1 x Mounting Clip to secure AL-QC10 Carbon filter

1 x Self Piercing Saddle Valve Clamp Connection Connects To Copper Pipe

3m x length of 1/4" tubing (to connect to filter and faucet)

1 x High Quality Chrome Faucet complete with all fittings

Installation:
The kit is suitable for standard 12 to 15mm copper pipe. For safety locate your mains water STOP COCK before installing. Select the position of the tap on your counter or sink unit. TIP Ensure you have room underneath to connect filter to bottom of tap.

Drill a 12mm hole. TIP: use a smaller drill bit first to make a “pilot hole”.

Remove nut from tap tail and push tap tail through hole, first making sure that the washers are fitted to tail as per photo. (Large chrome washer, large rubber washer then small rubber washer).

Now insert tap tail through the hole. Then secure the tap underneath the counter by using the other washers. (Small rubber washer, castellated washer then the nut). Use a spanner to tighten up the bottom securing nut.

Connect the spare plastic pipe to the bottom of the tap:
(IF NOT ALREADY CONNECTED)This is the pipe that is not connected to the saddle valve.

Place the 2nd nut onto this tube, then the small white plastic “olive”. Push the tube up into the tap tail an inch or so. Now bring the nut up so that the white small white plastic “olive” is pressed into the tap tail. (This makes it water tight). Finger tighten this nut then secure firmly with at least one full spanner turn.

Position Your Aqualogis AL-QC10 Inline Filter under your sink. Place the fixing bracket on the filter and choose a suitable positon (often this is attached to the side of the undersink cupboard). Mark with a pencil. Remove brackets from filter and screw into place

Connect the saddle valve to the cold water pipe. Finger tighten the clamp by turning the bottom nut. Then tighten properly with a spanner. Do NOT over tighten. One or two spanner turns after finger tight should do. Do not split your pipe ! The aim is simply to make the saddle valve immovable on the pipe.

Fitting Your New AL QC10 Filter

Take your inline filter and check flow direction is correct (see Flow arrow on the filter. Arrow points in the direction the water should flow ie to your tap).

Select your first tube end ie from tap or water connection. Aqualogis AL-QC10 has 1/4" PushFit connectors both ends just push the water tube into the filter about 19mm both ends.

Flush the New Inline AL-QC10 Filter Through. Turn water supply to fridge back on and run water through for AT LEAST two minutes plus. This is to remove natural carbon dust and trapped air. When water runs clear it's ready to drink

Check for leaks when flushing and double check for leaks 10 minutes later. Look for any tiny amount of leaking at the filter ends. If this happens redo fittings as above.

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi ut aliquip ex ea commodo consequat.